Jump to content
Sign in to follow this  
daystate huntsman

Daystate cocking problem

Recommended Posts

Hi everyone,

 

This is my first post (after looking through older posts) to see if I can get some help with a problem cocking a Daystate Huntsman Classic. It works perfectly at room temperature but when outside (cold) it won't "catch". I am presuming this must be to do with trigger adjustment but I have tried backing off as advised by the manual. Will I need to touch any of the other trigger adjustments?

 

Many thanks,

DH

Share this post


Link to post
Share on other sites

Thanks Ray,

 

I will give it another try tomorrow - I just didn't want to make it worse so I changed as little as possible! It must be quite a small change required as it works fine indoors (room temperature).

 

DH

Share this post


Link to post
Share on other sites

Hi,

 

Just to give some feedback - I have adjusted trigger (seem to have run out of adjustment) and now the rifle cocks(sort of) but I am not confident that it is securely "caught" and now have occasional accidental trigger release.

 

I'm not sure what else I should now do - could the trigger sear faces be damaged? I have started a seperate thread (although maybe related on why my shots - chrono'd) are inconsistent.

 

DS

Edited by daystate huntsman

Share this post


Link to post
Share on other sites

Hi

 

I have seen a similar problem to this, were you could adjust the ‘weight’ adjustment but it would make no difference to the trigger pull and also the gun would fire (occasionally) without the trigger being touched and it seemed more likely to happen in colder weather.

It turned out to be an issue with the spring which engages the sears when the gun is cocked, it had been distorted when it was fitted and was not giving enough pressure to engage the sears fully.

 

I have included a picture of a Daystate Harrier trigger so you can see the spring I’m talking about, this unit is similar but not identical to the Huntsman trigger unit. You can remove the parts by just removing the pins for each part of the assembly, trigger first and the rocker part of the sear, no need to remove the other part and then you can check the springs, be careful not to loose the springs.

 

It’s not a difficult job but if you don’t feel confident about it you will need to take it to a gunsmith.

 

I hope this is useful to you.

post-31759-1329141246_thumb.jpg

Share this post


Link to post
Share on other sites

Grease? Many lubes will stiffen when cold and that can prevent the cocking mechanism from engaging in some spring guns.

Edited by Cliff

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×